Accessible Housing From Wikipedia,
the free encyclopedia
Accessible housing refers to the construction or modification (such as through renovation or home modification) of housing to enable independent living for persons with disabilities. Accessibility is achieved through architectural design, but also by integrating accessibility features such as modified furniture, shelves and cupboards, or even electronic devices in the home.
|Please click-it to be larger for the text+image...|
Great Britain applies the most widespread application of home access to date. In 1999, Parliament passed Section M, an amendment to residential building regulations requiring basic access in all new homes. In the United States, the 1988 Amendments to the Fair Housing Act added people with disabilities, as well as familial status, to the classes already protected by law from discrimination (race, color, gender, religion, creed, and country of origin). Among the protection for people with disabilities in the 1988 Amendments are seven construction requirements for all multifamily buildings of more than four units first occupied after March 13, 1991. These seven requirements are as follows:
- An accessible building entrance on an accessible route,
- Accessible common and public use areas,
- Doors usable by a person in a wheelchair,
- Accessible route into and through the dwelling unit,
- Light switches, electrical outlets, thermostats and other environmental controls in accessible locations,
- Reinforced walls in bathrooms for later installation of grab bars, and
- Usable kitchens and bathrooms.
Sinks and cooking areas typically need to be designed without cupboards below them, to permit the legs of the wheelchair user to roll underneath, and countertops may be of reduced height to accommodate a sitting rather than standing user. In some cases two food preparation areas may be combined into a single kitchen to permit both standing and wheelchair users.
In spite of these advancements, the housing types where most people in the United States reside – single-family homes – are not covered by the Americans with Disabilities Act, the Fair Housing Act, or any other federal law with the exception of the small percentage of publicly funded homes impacted by Section 504 of the Rehabilitation Act. As a result, the great majority of new single-family homes replicate the barriers in existing homes.
Renovations for Accessibility
Homeowners may be challenged by the need to find renovators familiar with accessible design issues. The federal government of Canada and the provincial governments work jointly to share the cost of offering reimbursement programs for homeowners in need of house renovations for accessibility. These programs improve the ability of homeowners to fund house modifications, through renovating existing houses.
Adaptations and Accommodations
Many ranch style homes and manufactured homes utilize a main floor slightly raised above ground level, but have an overall flat layout with either a crawlspace or slightly raised basement below for plumbing, electrical, and heating systems. These homes can be relatively easily modified to accommodate wheelchairs and walkers, with the installation of a long low-rise ramp outside the building, up to the house entrance, placed over the existing stairway. This ramp can then be removed at a later time, reverting to the stairway entrance if the handicapped access is no longer necessary.
Split level homes tend to be designed with multiple internal stairways and half-floor landings inside the building. There may be an entrance area inside the building at ground level, with stairs inside the entrance that immediately go up and down from the ground level. These homes are difficult to accommodate inexpensively since there is often no space available inside the structure to install long sloping wheelchair ramps to access the various floors. It may be possible to retrofit stair lifts into the stairwells or wheelchair lifts into balconies near the stairwell.
Multi-story homes can sometimes be accommodated by installing a private residential elevator, which is usually much less expensive and has fewer design and layout requirements than a full commercial elevator. Homebuilders can in some cases plan for a future residential elevator by designing closet spaces in each floor stacked vertically with the same dimensions and location. At a later time the closet floors and ceilings are removed and the elevator equipment is installed into the open shaft.
Below are some current suggested architectural features of a universally-accessible house:
|Kitchen||Hallways and Stairways||Living Room / Family Room||Bathroom|
|A side-opening, wall-mounted oven with a pullout board beneath||Hallways should be 1,200 mm (3.9 ft) wide||A doorless entry with no threshold||The bathroom door should be a minimum of 865 mm (34.1 in) wide and open outward to avoid obstructing the limited space inside|
|Pull-out work boards at varying heights||Stairs should be 1 metre (39 inches) wide and a maximum of 280 mm (11 in) deep||A uniform level throughout the room eliminates abrupt changes that can create trip hazards||Dual lever faucets are easier to use than single lever or ball-type faucets|
|Knee space left under the sink or a cooktop||The maximum riser height should be 180 mm (7.1 in)||The installation of extra electrical, telephone and cable outlets accommodates technology and provides for maximum flexibility in furniture arrangement||Install non-slip flooring for any area that is prone to getting wet|
|Pull-out drawers for storage rather than deep shelves||Flights of stairs should be straight with the same number of steps in each flight with a minimum of three and maximum of twelve risers||Light switches should be accessible from a sitting position and one switch should be located at the entrance to the living room||Leave free space on at least one side of the toilet for improved access|
Aging in Place and Accessibility
A growing trend among senior citizens is to "age in place", reflecting a desire to retain independence for as long as possible. Adaptations for seniors take into account the most common physical impairments affecting the elderly. For example, a common cause of serious injury for seniors is falling inside the home. Adding handrails and grab bars throughout the home, particularly in bathrooms and along stairways, helps reduce the risk of falling. Other adaptations that improve accessibility for seniors include: easy-to-reach work and storage areas in the kitchen; reaching devices to grab objects on high shelves; lever handles on doors; toilet seat risers; walk-in showers; and bathtub and shower seats.
Alzheimer Disease and Housing Adaptations
Alzheimer disease presents specific challenges for caregivers, who need to make the home as accessible as possible to the elderly resident, while keeping safety features in mind. Removable stove switch knobs, locks on kitchen cabinets, electric kettles with automatic shut-off, and adding lighting to eliminate shadows in the house can all help caregivers to reduce dangers to the person with Alzheimer disease. Other features that can improve the well-being of the elderly person can include marking doors with conspicuous and distinct signs or objects such as ribbons or wreaths, can assist memory. Adding a cot or bed to the main floor of the house to allow the elderly person to rest without climbing stairs to a bedroom can be helpful to the Alzheimer patient. Furniture and clutter can also be removed to make the house more safe for an elderly person inclined to pace or wander.
See the full article:
Accessible Housing From Wikipedia, the free encyclopedia